Case Erector Assembly

1. 3D Model

Case Erectors is used to automatically form and fold shipper flaps by using pneumatic mechanism.
Case erector uses vacuum station-1 for holding the shipper and pneumatic cylinder assembly is used to close bottom minor and major flaps of the shipper. After forming shipper, it is transferred to the tapping unit by using linear shipper push cylinder. At tapping Assembly shipper will get Prepare with bottom tape.

Important Precautions: -

READ this manual before operating or servicing this equipment.

ALWAYS remove power and wait at least 30 seconds before connecting / disconnecting any internal harnesses. Failure to observe these precautions may result in damage to, or destruction of the equipment.
ALWAYS take proper precautions when handling static sensitive devices.
SAVE this manual for future reference.
DO NOT allow untrained personnel to operate, clean, inspect, maintain, service or tamper with this equipment.
DO NOT connect or disconnect any digital or analogue components to the equipment with power connected or damage may result.

Refer click the below Maintenance Schedule for Magazine Assembly.