Taping Machine

1. 3D Model

The bottom taping machine is used to seal the shipper by using the bottom tape heads. The Case Errector Form the Shipper with bottom flap folding then it transfer to Tapping Assembly using Linear Shipper Transfer Cylinder.
The taping machine has the photoelectric sensors to sense bottom tape level and to detect shipper and two motor . After receiving the shipper from the Case Errector Assembly bottom tape will be applied.
The height and width of the taping machine will be adjusted manually by using the provided handle.

Important Precautions: -

READ this manual before operating or servicing this equipment.

ALWAYS remove power and wait at least 30 seconds before connecting / disconnecting any internal harnesses. Failure to observe these precautions may result in damage to, or destruction of the equipment.
ALWAYS take proper precautions when handling static sensitive devices.
SAVE this manual for future reference.
DO NOT allow untrained personnel to operate, clean, inspect, maintain, service or tamper with this equipment.
DO NOT connect or disconnect any digital or analogue components to the equipment with power connected or damage may result.

Refer click the below Maintenance Schedule for Magazine Assembly.